Asus Q170M2/CDM/SI Manual page 72

CPU Q-Fan Control [PWM Mode]
[Disabled]
[PWM Mode]
CPU Fan Speed Low Limit [200 RPM]
This item appears only when you enable the CPU Q‑Fan Control feature and allows you
to disable or set the CPU fan warning speed. Configuration options: [Ignore] [100RPM]
[200RPM] [300 RPM] [400 RPM] [500 RPM]
CPU Fan Profile [Standard]
This item appears only when you enable the CPU Q‑Fan Control feature and allows you to
set the appropriate performance level of the CPU fan.
[Standard]
[Silent]
[Turbo]
[Manual]
The following four items appear only when you set CPU Fan Profile to [Manual].
CPU Upper Temperature [70]
Use the <+> and <‑> keys to adjust the upper limit of the CPU temperature. The values
range from 20ºC to 75ºC.
CPU Fan Max. Duty Cycle(%) [100]
Use the <+> and <‑> keys to adjust the maximum CPU fan duty cycle. The values
range from 20% to 100%. When the CPU temperature reaches the upper limit, the
CPU fan will operate at the maximum duty cycle.
CPU Middle Temperature [25]
Use the <+> or <‑> keys to set the value for CPU Middle Temperature. The range of
the values depends on the CPU installed.
CPU Fan Middle Duty Cycle(%) [20]
Use the <+> or <‑> keys to adjust the CPU fan middle duty cycle. The values range
from 20% to 100%. When the CPU temperature reaches the middle value, the CPU fan
operates at the middle duty cycle.
CPU Lower Temperature [20]
Displays the lower limit of the CPU temperature.
CPU Fan Min. Duty Cycle(%) [20]
Use the <+> and <‑> keys to adjust the minimum CPU fan duty cycle. The values
range from 20% to 100%. When the CPU temperature is under the lower limit, the CPU
fan will operate at the minimum duty cycle.
2‑36
Disables the CPU Q‑Fan control feature.
Enable the CPU Q‑Fan control in PWM mode for 4‑pin CPU fan.
Sets to [Standard] to make the CPU fan automatically adjust depending on
the CPU temperature.
Sets to [Silent] to minimize the fan speed for quiet CPU fan operation.
Sets to [Turbo] to achieve maximum CPU fan speed.
Sets to [Manual] to assign detailed fan speed control parameters.
Chapter 2: Getting started