Table of Contents
Advertisement
Skill Level = Myriad Semi Bold
All instructions and
precautions outlined in this
manual should be strictly
followed to ensure safe
bluehighway font
operation of your model.
1 2 3 3+ 4 5
This model is not intended
for use by children under
14 years of age without the
supervision of a responsible
and knowledgeable adult.
No previous experience with radio
controlled models is required.
Models require a minimum of setup,
maintenance, or support equipment.
For Expert Drivers
1
4 • 1/16 SUMMIT
SAFETY PRECAUTIONS
All of us at Traxxas want you to safely enjoy your new model. Operate
your model sensibly and with care, and it will be exciting, safe, and
fun for you and those around you. Failure to operate your model in
a safe and responsible manner may result in property damage and
serious injury. The precautions outlined in this manual should be
strictly followed to help ensure safe operation. You alone must see
that the instructions are followed and the precautions are adhered to.
Important Points to Remember
• Your model is not intended for use on public roads or congested areas
where its operation can conflict with or disrupt pedestrian or vehicular
traffic.
• Never, under any circumstances, operate the model in crowds of people.
Your model is very fast and could cause injury if allowed to collide with
anyone.
• Because your model is controlled by radio, it is subject to radio
interference from many sources that are beyond your control. Since
radio interference can cause momentary losses of radio control, always
allow a safety margin in all directions around the model in order to
prevent collisions.
• The motor, battery, and speed control can become hot during use. Be
careful to avoid getting burned.
• Don't operate your model at night, or anytime your line of sight to the
model may be obstructed or impaired in any way.
• Most importantly, use good common sense at all times.
Speed Control
Your XL-2.5 is an extremely powerful electronic device capable of
delivering high current. Please closely follow these precautions to prevent
damage to the speed control or other components.
• Disconnect the Battery: Always disconnect the battery from the speed
control when not in use.
• Transmitter on First: Switch on your transmitter first before switching
on the speed control to prevent runaways and erratic performance.
• Don't Get Burned: The heat sink can get extremely hot, so be careful
not to touch it until it is cool. Supply adequate airflow for cooling.
• Use the Factory Installed Connectors: If you decide to change the
battery or motor connectors, only change one battery or motor
connector at a time. This will prevent accidentally mis-wiring the speed
control. If the XL-2.5 is not wired exactly as shown in the diagram, it can
be damaged! Please note that modified speed controls can be subject
to a rewiring fee when returned for service.
• Insulate the Wires: Always insulate exposed wiring with heat shrink
tubing to prevent short circuits.
• 4-7 cells 2/3A NiMH cells or 2 LiPo cells (2s) Only: The XL-2.5 can only
BELOW TEXT HAS BEEN UPDA
accept a maximum input voltage of 8.4 volts (NiMH), 7.4 volts (2s LiPo).
Kent wants maintenance text
Always adhere to the minimum and maximum limitations of the XL-2.5 as
stated in the specifications table.
• No Reverse Voltage: The speed control is not protected against
Choose the Model That is Righ
reverse polarity voltage. When changing the battery and/or motor, be
sure to install the same type of connectors to avoid reverse polarity
damage to the speed control. Removing the battery connectors on
No previous experience with radio controlled models is req
the speed control or using the same-gender connectors on the speed
Models require a minimum of setup, maintenance, or supp
control will void the product's warranty.
• No Schottky Diodes: External schottky diodes are not compatible with
Previous experience with radio controlled models is recom
reversing speed controls. Using a schottky diode with the XL-5 will
Models require a higher level of setup, maintenance, or su
damage the ESC and void the 30-day warranty.
• Using Two Batteries: When using two batteries, the batteries must be
Previous experience with radio controlled models is manda
connected in parallel. Never connect two batteries in series, this will
models are capable of high speeds, requiring experienced
Models require detailed setup, and/or maintenance proced
cause the ESC to fail. See page 14 for more information.
support equipment.
Recycling Your Traxxas Power Cell NiMH Battery
Previous experience with radio controlled models is manda
Traxxas strongly encourages you to recycle your Power Cell NiMH
These models are capable of very high speeds and require
battery when it has reached the end of its useful life.
level of skilled driving control. Models require detailed setu
battery in the trash.
All Power Cell NiMH battery packs display the RBRC
nance procedures with required support equipment.
(Rechargeable Battery Recycling Corporation) icon, indicating they are
For Expert Drivers Only. This product is capable of extre
recyclable. To find a recycling center near you, ask your local hobby dealer
and acceleration! It carries our highest skill level rating and
or visit www.call2recycle.org.
for expert drivers only. Experience with nitro-powered radio
models is required!
Do not throw your
Advertisement
Table of Contents
