Advertisement

Quick Links

Instructions for use
CM 7945 IXA

Advertisement

Table of Contents
loading

Summary of Contents for Ariston CM 7945 IXA

  • Page 1 Instructions for use CM 7945 IXA...
  • Page 3 Instructions for use...
  • Page 7: Table Of Contents

    Safety instructions Safeguarding the environment Built-in installation Product description Using the appliance for the first time Switching on and preheating Making coffee (using coffee beans) Changing the amount of coffee in the cup Adjusting the coffee grinder Making espresso with ground coffee (instead of beans) Running off hot water Making cappuccino (using the steam function) Changing and setting menu parametrs...
  • Page 8: Safety Instructions

    Safety instructions Important to be read and observed Before using the appliance, read these safety instructions. Keep them nearby for future reference. These instructions are also available on www.aristonchannel.com These instructions and the appliance itself provide important safety warnings, to be observed at all times.
  • Page 9: Safeguarding The Environment

    installation operation - risk of electrical shock. During installation, make sure the appliance does not damage the power cable - risk of fire or electrical shock. Only activate the appliance when the installation has been completed. The appliance can be installed above a built-in oven only if the latter is equipped with a cooling fan system.
  • Page 10: Built-In Installation

    Built-in installation Check the minimum measurements required for correct installation of the appliance. The coffee machine must be installed in a column unit, which must in turn be securely fixed to the wall by means of commercial brackets. Attention: • Disconnect the appliance from the mains before carrying out any installation work or servicing.
  • Page 11 Secure the power supply cable with the clip provided. The power supply cable must be long enough to allow the machine to be removed from the housing in order to fill the coffee bean container. Regulations require that the appliance is earthed. Electrical connection must be carried out by a qualified electrician in accordance with the manufacturer’s instructions.
  • Page 12: Product Description

    Product description Appliance Control panel See image A on page 4. See image B on page 4. N.B.: the touch-control buttons are activated at the Cup tray lightest touch of a finger Service door Coffee feed Display: guides the user through use of the machine Coffee grounds container MENU Button...
  • Page 13: Using The Appliance For The First Time

    Using the appliance for the first time • Coffee has been used to factory test the machine and it is therefore completely normal for there to be traces of coffee in the mill. • Customize water hardness as soon as possible, following the instructions in paragraph Setting water hardness. 1.
  • Page 14: Making Coffee (Using Coffee Beans)

    Making coffee (using coffee beans) 1. The machine is factory-set to make coffee with a standard taste. You can choose coffee with the following tastes: extra-mild, mild, standard, strong or extra-strong, with the option of using pre-ground coffee. To choose the (B3) (Figure 7) repeatedly until the required taste is displayed.
  • Page 15: Changing The Amount Of Coffee In The Cup

    Changing the amount of coffee in the cup The appliance is factory-set to automatically deliver the following amounts of coffee: • Espresso, • Small cup, • Medium cup, • Large cup, • Mug. To modify these quantities and set the amount of coffee desired, for example changing the amount of espresso, proceed as follows: (B4) repeatedly until the display shows ESPRESSO CUP.
  • Page 16: Running Off Hot Water

    Running off hot water • Always check that the machine is ready for use. • Turn the cappuccino maker outwards and place a container underneath. • Press button (B11) the display will show HOT WATER PRESS , press (B7) to confirm. The display shows HOT WATER and hot water runs out of the cappuccino maker, filling the container below (Do not run off hot water for more than 2 minutes at a time).
  • Page 17: Changing And Setting Menu Parametrs

    Changing and setting menu parametrs When the machine is ready for use, you can access the menu in order to change the following parameters or functions: • RINSING • ADJUST TIME • LANGUAGE • AUTO-START • DESCALING • COFFEE TEMPERATURE •...
  • Page 18 Descaling Descaler contains acids. Observe the manufacturer's safety warnings given on WARNING the descaler pack. N.B.: Only use descalers recommended by the manufacturer. Failure to do so invalidates the machine warranty. Failure to descale the machine regularly will also invalidate the warranty. When the display shows the message DESCALE!, it is time to descale the machine.
  • Page 19 • Press (B7). • Press buttons (B5) and (B6) to select the number of dots corresponding to the number of red squares which have formed on the test strip (for example, if the test strip shows 3 red squares, you need to select the message );...
  • Page 20: Cleaning And Maintenance

    Cleaning and maintenance Cleaning the machine Do not use solvents or abrasive detergents to clean the machine. A soft damp cloth will suffice. The following machine parts must be cleaned regularly: • Coffee grounds container (A4). • Drip tray (A14). •...
  • Page 21: Switching Off The Appliance

    Cleaning the brewing unit The brewing unit must be cleaned at least once a month. The brewing unit (A5) cannot be removed while the appliance is switched on. Do WARNING not attempt to use force to remove the brewing unit. 1.
  • Page 22: Displayed Messages

    Displayed messages DISPLAYED MESSAGE POSSIBLE CAUSE REMEDY - Fill the tank with water and/or - The water tank is empty or FILL TANK! insert it correctly, pushing it as far incorrectly positioned. as it will go. GROUND TOO FINE ADJUST MILL! - The ground is too fine so the - Turn the grinding adjustment PRESS...
  • Page 23: Troubleshooting

    Troubleshooting Below is a list of some possible malfunctions. If the problem cannot be resolved as described, contact After-sales Service. PROBLEM POSSIBLE CAUSE REMEDY - The cups have not been pre- - Heat the cups by rinsing them heated. with hot water. - The brewing unit has cooled - Before making coffee, heat the down because 2/3 minutes have...
  • Page 24 Printed in Italy 06/2017 400011038944...

Table of Contents