Mounting Installation - Fisher & Paykel DCS WDV2-30 Installation Instructions And User Manual

INSTALLATION INSTRUCTIONS

MOUNTING INSTALLATION

The lower rear corners of the cabinet need to provide proper support to the back of the warming drawer and
the anti-tip mounting clips. A 120 volt AC outlet should be located no further than 36 inches from the back
center of the warming drawer.
The bottom rear section of the cabinet should be made of solid plywood or two 2x4 beams. It holds the anti-tip
mounting clips and supports the weight of the warming drawer, which is 90 lbs. (see Figs. 5 and 6). If two 2x4
beams are used, the distance between their centers must be 20" to be able to secure the Warming Drawer.
STEP 1
Use the screws provided and attach the mounting clips. They must be installed for anti-tip safety to the bot-
tom support at the back. See placement dimensions in the figures below (see Figs. 5 and 6).
STEP 2
Plug power cord into AC outlet. Slide the body onto the anti-tip mounting clips (see Fig. 6).
STEP 3
Use the two supplied 1-1/2" long screws through the two embossed holes (see Fig. 7) to secure the front of the
warming drawer.
21-1/2"
Fig. 5
Slide body
on to anti-tip
mounting clips
mounting clips
7
US
CA