ASROCK IMB-1211-D User Manual page 30

SATA3 Connectors
(SATA3_1~4: see p.14, No. 28)
* M2_2 and SATA3_1 share lanes. If either one of them is in use, the other one will be
disabled.
USB 2.0 Headers
(9-pin USB2_5_6, USB2_7_8:
see p.14, No. 23)
Front Panel Audio Header
(9-pin HD_AUDIO1)
(see p.14 No. 27)
1. High Definition Audio supports Jack Sensing, but the panel wire on
the chassis must support HDA to function correctly. Please follow the
instruction in our manual and chassis manual to install your system.
2. If you use AC'97 audio panel, please install it to the front panel audio
header as below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for HD audio panel only. You don't
need to connect them for AC'97 audio panel.
E. To activate the front mic.
Go to the "FrontMic" Tab in the Realtek Control panel. Adjust
"Recording Volume".
3W Audio AMP Output Wafer
(4-pin SPEAKER1)
(see p.14 No. 26)
SATA3_4 SATA3_1
SATA3_2 SATA3_3
OUT_RET OUT2_L
J_SENSE
MIC_RET OUT2_R
PRESENCE# MIC2_R
GN D MIC2_L
1
1
Signal
PIN
Name
1 OUTLN
30
These four Serial ATA3 (SATA3)
connectors support SATA data
cables for internal storage
devices. The current SATA3
interface allows up to 6.0 Gb/s
data transfer rate.
There are two headers on this
motherboard. Each USB 2.0
header can support two ports.
This is an interface for front
panel audio cable that allows
convenient connection and
control of audio devices.
Signal Signal
PIN PIN
Name Name
2 OUTLP 3 OUTRP
Signal
PIN
Name
4 OUTRN