Setting Passwords; Passwords From The Control Panel - Sharp AR-C360P Software Configuration Manual

7

7-149 Setting passwords

Setting passwords
You can set or change the Administrator password for the Fiery.
Anyone with the Administrator password can modify the Setup
options, and control the flow and order of print jobs with the job
management tools.
When the Fiery is installed, there is no password. If you do not
create an Administrator password, users are not required to enter
a password to modify the Setup or use the administrator functions
in the job management tools. If an Administrator password has
been set previously, you are required to enter it when you run
Setup. Use the and keys to select the characters and the
ENTER key to advance and complete (see "Types of Setup
screens" on page 4-63).
Caution:If you decide to set an administrator password make sure
you keep a careful note of it. If you lose or forget this password it
cannot be recovered for you, and the internal hard disk drive
containing the operating system and all settings will need to be
replaced.

Passwords from the Control Panel

For more information on Administrator access privileges, see
page 3-52. For information on controlling print jobs with the job
management tools, see the Job Management Guide.
The Operator password can be set and changed only from
Note:
Fiery WebSetup, or Command WorkStation.
To change the Fiery password
1. Scroll through the main Setup menu and choose Change
Password.
2. Enter and confirm the password, as follows.
Sharp AR-C360P EFI Configuration Guide - 149