Table of Contents
Advertisement
OPERATING INSTRUCTION
Any attempt to use this unit under temperature conditions beyond the specified range may cause the air
conditioner protection device to start and unit may fail to operate. Therefore, ensure to use the air conditioner
within the specified limits as mentioned below:
In case of power cut when the units restarts after supply is restored or if the user switch the mode of operation
from one mode to another, the compressor protection device is activated. In this case compressor resumes
operation after 3 minutes.
Characteristics of heating operation (applicable to heat pump models)
Pre-heating:
When heating function is activated, the indoor unit takes 2-5 minutes for preheating, after that the unit will
start heating and blow warm air.
Defrosting:
During heating function frost is slowly accumulated on outdoor unit, under this situation the unit will switch
to defrost mode automatically to improve heating effect. During defrost cycle indoor and outdoor fan will stop
running. Unit will resume heating once defrosts cycle is completed.
Emergency button:
Open the panel and find the emergency button on the control box. Use this button when remote control fails to
operate. (Always press emergency button with insulated material).
Current Status
Stand by
Stand by (For heat
pumps)
Running
Operation
Press emergency
button once
Press emergency
button twice in 3 sec
Press emergency
button once
14
Response
Beeps once
Beeps twice
Beeps for a while
Enter Mode
Cooling
Heating
OFF
Advertisement
Table of Contents
