NETGEAR WNHDE111 Instruction Manual page 3

FCC Statement
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.
This equipment generates uses and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is
no guarantee that interference will not occur
in a particular installation determined by
turning the equipment off and on, the user is
encouraged to try to correct the interference
by one of the following measure:
Reorient or relocate the receiving antenna.
Increase the separation between the
equipment and receiver.
Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
Consult the dealer or an experienced radio/
TV technician for help.
To assure continued compliance, any
changes or modifications not expressly
approved by the party responsible for
compliance could void the user's authority to
operate this equipment. (Example- use only
shielded interface cables when connecting to
computer or peripheral device.)
FCC Radiation Exposure Statement
This equipment complies with FCC RF
radiation exposure limits set forth for an
uncontrolled environment. This equipment
should be installed and operated with a
minimum distance of 20 cm between the
radiator and your body.
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions:
1) this device may not cause harmful
interference, and
2) this device must accept any interference
received, including interference that may
cause undesired operation.
This transmitter must not be co-located or
operating in conjunction with any other
antenna or transmitter.
The antennas used for this transmitter must
installed to provide a separation distance for
at least 20 cm from all persons and must not
be co-located or operating in conjunction with
any other antenna or transmitter.
This equipment marketed in USA is restricted
by firmware to only operate on 5G.