Makita DTW284 Instruction Manual page 8

Changing the impact force/mode
2
3
4
5
Fig.8
► 1. Changed in four steps 2. Hard impact mode
3. Medium impact mode 4. Soft impact mode
5. Reverse rotation auto stop mode 6. Button
Specifications of each impact force grade
Impact force grade displayed
on panel
Hard
Medium
Soft
Reverse rotation auto stop
mode
NOTE: Reverse rotation auto stop mode is available only when the tool rotates counterclockwise. When rotating
clockwise in reverse rotation auto stop mode, the impact force and speed are the same as Hard impact mode.
1
6
Maximum blows
-1
3,500 min (/min)
-1
2,600 min (/min)
-1
1,800 min (/min)
-1
3,500 min (/min)
You can change the impact mode in four steps: hard,
medium, soft, and reverse rotation auto stop mode.
To select the step, press the button
You can change the impact force within approximately
one minute after releasing the switch trigger.
Hard, Medium, and Soft impact mode allows a tighten-
ing suitable to the work.
The function of reverse rotation auto stop mode works
only with pulling the trigger fully in counterclockwise tool
rotation. When the bolt/nut gets enough loosened, the
tool stops the impact and rotation.
Application
Tightening when force and
speed are desired.
Tightening when you need
good controlled power.
Tightening when you need fine
adjustment with small diameter
bolt.
Loosening with auto stop
function.
8 ENGLISH
.
Work
Assembling the steel frame.
Assembling or disassembling
scaffolds or framework.
Assembling furnitures.
Disassembling bolts/nuts.