GE AJEQ10DCF Owner's Manual And Installation Instructions page 13

Read these instructions completely and carefully.
Power cord may include a current interrupter device.
A test and reset button is provided on the plug case.
The device should be tested on a periodic basis by first
pressing the TEST button and then the RESET button.
Phillips-head
screwdriver
Adjustable Wrench
USE GE
RAB46A ,46, Use these kits for all GE
47A, 47, 48A, models and other brands
48B & 48
RAK65A1
RAK690 RAB36, 37, 38, 46, 47 or 48
RAG13 RAB36, 37, 38, 46, 47 or 48
RAG14E RAB36, 37, 38, 46, 47 or 48
Operation by A Remote Control device is shipped with GE Built-In Air Conditioners. When operated by Re-
Remote Control mote Control GE Built-in ACs meet all federal ADA compliance requirements.
Operation at GE Built In Air Conditioners intended to be operated at the control panel meet federal ADA
compliance requirements when installed so that the controls are more than 15" from ground
and less than 48" from the ground.
Operation by GE Air Conditioners intended to be operated via a wall thermostat meet federal ADA compli-
Thermostat ance requirements when used in conjunction with an ADA compliant wall thermostat mounted
more than 15" and less than 48" from the ground.
Installation Instructions
Ruler or Tape Measure
Drill
Pencil
not listed
All GE Models
(J-Chassis)
(J-Chassis)
(J-Chassis)
If the TEST button does not trip or if the RESET button
will not stay engaged, discontinue use of the air
conditioner and contact a qualified service technician.
Scissors or knife
Level
Standard wall case for "J" model chassis. RAG13 stamped
aluminum exterior grille included. Remove the existing case
and replace.
Kit for window installation.
If you attach a custom architectural outdoor grille, use this kit
to ensure proper airflow.
Standard aluminum exterior grille (included with RAB46, 47, 48,
RAB46A, 47A, 48A, and 48B wall cases).
Architectural louvered exterior grille.
Hand or Saber Saw
13