Operating Instructions - lifeSMART HT1167 Manual

OPERATING INSTRUCTIONS

1 . Turn the heater on or off by pressing the Power
button on the control panel (C) or by pressing
the Power button on the remote control (B) .
Once the power is off, heating elements will
stop working first . The fan will continue working
for up to 90 seconds to dispense residual heat
inside the heater . This is a normal function .
2 . Select a heat setting by pressing the HEAT
button on either the control panel (C) or the
remote control (B) to toggle between the three
heat settings .
Power for heat-up mode is 1,500 W; heat-down
is 1,000 W . ECO mode is an Economic Energy
Saving Function . When ECO mode is chosen,
the heater will operate to maintain a constant
warm 68°F
Note: The ECO LED light will only illuminate
when the ECO function is active and the
ambient room temperature falls below
68ºF / 20ºC .
3 . Set the temperature by pressing the arrows on
the control panel (C) or the remote control (B) .
You can set the temperature on the heater
anywhere between 50°F and 90°F or between
10°C and 32°C . Once you have chosen the
desired temperature, the heater will remain
on until the room temperature increases to the
temperature on the digital display . The heater
will cycle on and off to maintain the desired
room temperature .
To view the ambient temperature press and
hold the timer button for 5 seonds on the
control panel (C) or short press on the remote
control (B)
Note: To switch between Fahrenheit and
Celsius, press and hold the TEMP UP
button on the control panel (C) for 3
seconds .
Note: To engage the child lock on the control
panel (C), press and hold the temp UP
and temp DOWN buttons 5 seconds .
Deactivate the lock by repeating these
steps .
1
C
2
C
HIGH
3
C
11
B
B
LOW ECO
B
OR