Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
1. Remove all packing materials from the oven cavity, (do not remove the waveguide cover), and the feature
sticker from the outside of the door, if there is one. Check the unit for any damage, such as a misaligned door,
damaged door seals around the door or dents inside the oven cavity or on the door. If there is any damage,
please do not operate the oven until it has been checked by a SERVICE CENTRE APPROVED BY SHARP
and repaired, if necessary.
2.
Accessories provided
1 ) Operation manual and Cook book
When the oven is mounted on a kitchen countertop, on a shelf or in a cabinet, allow a space of at least
15cm on the top, 10cm on both sides and 5cm at the rear of the oven for adequate air circulation.
Additionally when installing on a shelf or in a cabinet, the minimum dimension of the shelf or cabinet
should be 719mm(W)×467mm(H)×456mm(D).
This built-in kit has been tested according to Australian/New Zealand Standard AS/NZS60335
4. Neither the manufacturer nor the distributors can accept any liability for damage to the machine or
personal injury for failure to observe the correct electrical connecting procedure.
The A.C. voltage must be single phase 230 – 240V, 50Hz.
5. This appliance must be earthed.
6. Operate the oven from a general purpose domestic outlet.
If a generator is used, do not operate the oven with non-sinusoidal outputs.
OVEN DIAGRAM
B
6
3
5
D
4
1. Door open button
2. Oven lamp
3. Door hinges
4. Door safety latches
5. See through door
6. Door seals and sealing surfaces
7. Waveguide cover (Do not remove)
2
9
8
1
74
A
8. Control panel (See page 6)
9. LED Display
10. Ventilation openings
11. Power supply cord
12. Oven Cavity
13. Outer cabinet
14. Flatbed
5
0
C
Advertisement
Table of Contents
