Toshiba RAV-GV1601AT8P-E Service Manual page 64

Check Outdoor
code LED display
[P05]
[P07]
(Item without special mention Indicates part of outdoor unit.)
[Powersupply trouble] Voltage failure, open phase
Check the same items as [P04] trouble.
Is there no open phase of the
power supply?
NO
Does the supply voltage drop or rise
(AC342 to 457V)?
NO
Check noise filter P.C.board,
Interface (CDB) P.C.board
Failure → Replace
[Heat sink overheat trouble]
Is there any looseness in the screw stop
of the motor drive element IC21
of the compressor IPDU P.C. board,
the sub heat sink, and the diode bridge?
Are radiation grease properly applied?
NO
Does something block the
ventilation around the heastsink?
Does something block air flow
from the fan?
(Short circuit etc.)
YES
Check compressor IPDU P.C. board.
Failure → Replace
* When replacing Compressor IPDU P.C.board,
replace the fuse.
Check and troubleshooting
YES
YES
YES
NO
- 64 -
Correct wiring
Confirmation of
electrical work etc.
Apply radiation grease
to objective, retightening
of screw
Remove blocking matter,
Short circuit improvement