Page 1
YEPP Model Name : YP-P2 Model Code : YP-P2JCB/XEO YP-P2JQW/XEO SERVICE Manual YEPP CONTENTS 1. Precaution 2. Product Specification 3. Disassembly & Reassembly 4. Troubleshooting 5. Exploded View & Part List 6. PCB Diagram 7. Schematic Diagram YP-P2 Refer to the service manual in the GSPN (see the rear cover) for the more information.
5. You should not put any object or liquid into product. Otherwise, it may cause failure or mal-operation. 6. If replacement material is required, service engineer should use materials with the same standard. The use of non-standardized materials may cause failure of product. Samsung Electronics...
4. Minimize physical operation when handling with the ESD device for replacement without packing (Otherwise, namely friction between cloth fibers or lifting of the foot from the carpet floor may cause static electricity enough to damage the ESD device). Samsung Electronics...
- Allows easy communication using Bluetooth Full Screen Touch - named EmoTrueTM UI(User Interface) that allows to operate sensually all functions by using touch Icons on screen without uncomfortable buttons press. High Resolution 3” WIDE QVGA(480x272) LCD that allows to play 16:9 Wide Video Contents. WMV Format Supported (ready to Contents Service) Built-in Bluetooth Function A wireless networking technology that allows data transfer with Bluetooth-enabled stereo headsets, hands-free devices (cell phones), and other external devices, all without cables. Samsung Electronics...
Product Specification 2-2 Specifications Basic Specification YP-P2 Model Name Capacity Color Black White Red Wine Voltage DC 5.0V / 500mA Dimensions (WxDxH) / Weight 100 x 52 x 9.9 mm / 85g Case Injection+PAD Print, SUS Noise Ratio 85dB with 20KHz LPF (based on 1KHz 0dB) Earphone Output 20mW (16Ω)
Product Specification 2-3 Specifications Analysis Model Name YP-P2 YP-K5 Photo Storage TYPE Flash memory (DSP) Flash memory (MLC) SIZE: 3.0” 16.7M WQVGA Display Color: 16.7M LCD 1.71” Full Color OLED (Dot pitch: 0.0455(H) x 0.1365(V)) Resolution: 480RGB(H) x 272(V) 30 Hours of Music Playback with Earphones...
Product Specification 2-4 Accessories 2-4-1 Supplied Accessories Accessories Item Item code Remark Black AH30-00087E Earphones White AH30-00086H AH39-00899A USB Cable Samsung Service center AH46-00050A Program Installation CD Samsung Electronics...
HOLD KEY and POWER KEY then remove POWER KEY. 4) Use the aperture to remove VOLUME KEY at the opposite site. Be sure not to damage CABINET- BACK by using the aperture. Use new KEYS when re-assemble in case of damaging older KEYS. Samsung Electronics...
Page 11
USB CONNECTOR and remove TOUCH-PAD PANNEL FPCB from the ZIF CONNECTOR. When removing the FPC-TOUCH, be sure to use a pair of tweezers to avoid a tear. 4) Unplug the LCD CONNECTOR and then remove the PCB. Samsung Electronics...
Page 12
There will be possible to damage BATTERY effect from double coated tape. Re-attach a new double coated tape after removing an old thing, when assembling a BATTERY. 25.0 44.0 max 41 max A View <Location of BATTERY double coated tape.> Samsung Electronics...
Page 13
<Location of ASSY HOLDER-FRAME double coated tape.> 2) USE a pair of tweezers to remove CUSHION-LCD. Don’t remove the LCD which is glued HOLDER-Frame by force. 3) A view of the device after disassembly Samsung Electronics...
The power does not turn on. After insert battery to PCB, Is battery inserted to Main PCB Please TEST normally? Refer to wave pattern image of Table 4-1. Does the power turn on after recharging the battery? Completion Samsung Electronics...
Page 15
Refer to wave pattern image of Table 4-1. Check BATTERY power. Check MAIN 12Mhz clock IC803(+), IC804(-) Refer to wave pattern image of Table 4-1. Check power at the BATTERY Defective (single part). Completion Recheck after replacing the battery. Samsung Electronics...
Page 16
IC300(1PIN, 19PIN), IC301(1PIN, 4PIN), L300, L301, L303, L302 Result Check for HIGH input POWER Management Page, 7-3 L300 L301 L303 L302 POWER Management Page, 7-3 IC403 IC300 IC301 IC710 PCB Bottom Page, 6-3 <Table 4-1> Samsung Electronics...
Page 17
Are there skips and Check if IC704 is shorted. noises? Are the skips and noises even when playing another file? Does the same symptom persist even after upgrading the firmware to the latest version? Replace the board (needs thorough examination). Samsung Electronics...
Page 18
Troubleshooting Test Point C714 → 3.1V, C705 → 2.8V, L704 → 1.8V Result Check each output terminal. Audio CODEC Page, 7-7 IC403 IC300 IC301 IC710 PCB Bottom Page, 6-3 <Table 4-2> Samsung Electronics...
Page 19
TOUCH FPCB is defective. If the TOUCH is poor, replace the TOUCH PAD. Is the TOUCH PAD malfunctioning? Check if there is a sufficient gap be- tween the touch pad and the LCD. Recheck after replacing the touch pad (single part). Samsung Electronics...
Page 20
Troubleshooting Test Point C810 → 2.8V Result Check the output terminal. IC403 IC301 24PIN IO, Interface Page, 7-8 IC710 PCB Bottom Page, 6-3 <Table 4-3> Samsung Electronics...
Page 21
Is 32.768 KHz CLOCK being Is RTC CLOCK functioning normally? inputted normally? Refer to wave pattern image of Table 4-4. Completion Check the DIVIDE resistance. (R525 220KΩ, R526 1MΩ) (2 Wave pattern Peak-Peak 1.8V Check) Replace the board (needs thorough examination). Samsung Electronics...
Page 23
Refer to wave pattern image of Table 4-5. Check the LCD reset signal Check if the R908 LCD of the CPU. reset is in HIGH state. Refer to wave pattern image of Table 4-5. Completion 4-10 Samsung Electronics...
Page 25
12PIN → HIGH Refer to wave pattern image of Table 4-6. Check if Q305 is at LOW → USB charging HIGH or LOW level. HIGH Refer to wave pattern image of Table 4-6. HIGH → Adapter charging 4-12 Samsung Electronics...
Page 26
Test Point D303, IC300 15PIN, IC300 12PIN, Q305 Result D303 → 5V, IC300 15/12PIN → HIGH, Q305 → HIGH: ADAPTER, LOW: USB POWER Management Page, 7-3 IC403 IC300 IC301 IC710 PCB Bottom Page, 6-3 <Table 4-6> Samsung Electronics 4-13...
Page 27
“My Computer” as a in Device Manager? removable storage? Recheck after installing Is 12MHz CLOCK functioning the driver. normally? Can formatting be Is it accessible? done in Explorer? Can NAND FORMAT and BOOT Update be performed with DFU? Completion Defective 4-14 Samsung Electronics...
2. Check the contents of the folder that was decompressed. 3. Connect the YP-P2 to the PC. 4. Open the Removable Disk folder of the YP-P2. 5. Select the installation file in the folder that was decompressed, and then copy the upgrade files to the Removable Disk folder of the YP-P2.
Page 30
2. The device should be installed after establishing the USB connection with the PC. - After the initial installation, it will be connected automatically next time you connect. 1) Install the driver the first time you are connected to the PC. 2) Select the drive. Samsung Electronics 4-17...
Page 31
Troubleshooting 3) Browse to the FWDN\Driver directory and select the vtcdrv.sys file. 4) Click “Continue” to continue the driver installation. 5) Click “Finish” to complete the driver installation. 4-18 Samsung Electronics...
Page 32
Troubleshooting 3. Execute the FWDN.exe file. 1) Select the ROM file to be restored. Connect the device to the USB port. 2) Finish uploading to SDRAM. Samsung Electronics 4-19...
Page 33
Troubleshooting 3) Click on the WRITE button. ROM File WRITING 4) Confirm the Writing Complete message. 4-20 Samsung Electronics...
Page 34
When do you perform this procedure?: When NAND data is corrupted and after the DFU Update How to download a MAC address 1. Disassemble the YP-P2 case and check the MAC Address sticker inside. 2. Enter the following MAC Address in a blank text file and save it with the name shown below.
Exploded View & Part List 5. Exploded View & Part List 5-1 Exploded View AA060 AC010 AT300 AC357 AA139 AK290 AK200 AH228 AC115 AK420 AL093 AR061 AA001 This Document can not be used without Samsung’s authorization. Samsung Electronics...
Page 36
AH67-00467A LENS-LED;YP-P2,PMMA,CLEAR,-,T1.2,-,SMOK AR061 AH73-00127A RUBBER-LENS;YP-P2,RUBBER,-,60,-,BLK,-,-, AT300 AH59-01858A TOUCH/PANEL;87X45X0.15,CAPACITIVE,T1006 BATTERY 4301-001068 BATTERY-LI;3.7V,830mAH,LI-Polymer,4.1X44 AH07-00213A LCD;A030FL01,YP-P2,##,113.12X43.8X AH92-02759C ASSY PCB;YP-P2,8GB PCB ASSY MAIN PCB AH92-02759A ASSY PCB-MAIN;YP-P2_MAIN,MLC 2GB,Bluetooth 6003-001292 SCREW-TAPTITE;CH(0.3),+,B,M1.7,L3,ZPC(BL 6001-001677 SCREW-MACHINE;CH,+,M1.4,L2.0,CR PLT,SWRC Samsung Electronics This Document can not be used without Samsung’s authorization.
6-1 PCB Top CON801 CON900 TP10 TP11 IC602 IC600 IC700 IC703 IC400 HOLD KEY SDRAM 32MB POWER KEY IC100 TSP Connector USB Connector [24PIN] EARPHONE JACK CON800 BLUETOOTH ANT BLUETOOTH FM NAND Flash 26MHz VOLUME UP/DOWN KEY LCD Connector Samsung Electronics...
Page 47
PBA_CE # LCD Connector Pin No. Signal Pin No. Signal Pin No. Signal VDD2 VLED- VDDA VLED+ VLOUT3 VDDIO VSYNC VDD_25V HSYNC 9-16 RED [0~7] VLOUT2 DCLK 18-25 GREEN [0~7] VCOMH 27-34 BLUE [0~7] VCOML VCOM VCOM VDD3 Samsung Electronics...
DQ[0-31] 2.8V I/F 1.8V OPERATION 3.1V ADC 2.8V DAC GPIO UART NAND (DSP type) B/T ANT 32.768KHz USE RTC BLUE TOOTH MODULE with FM_MODULE BCM2048 SKUFBG 26MHz MAIN CLK This Document can not be used without Samsung’s authorization. Samsung Electronics...
Schematic Diagram 7-4 TCC7801 I/O Setting, Reset POWER TP13 TP8 / TP9 TP13 TP13 TP23 TP23 TP23 TP24 TP24 TP24 Samsung Electronics This Document can not be used without Samsung’s authorization.
Schematic Diagram 7-6 Audio CODEC TP19 POWER AUDIO TP19 TP19 TP20 TP20 TP21 TP20 TP21 TP21 Samsung Electronics This Document can not be used without Samsung’s authorization.
Schematic Diagram 7-8 WQVGA LCD Interface TP11 TP10 / TP11 / TP12 POWER TP10 TP11 TP12 TP12 TP10 Samsung Electronics This Document can not be used without Samsung’s authorization.