Trane 4WCZ6036B3000A Installation And Operation Manual page 13

10. Flexible duct connectors must be of a flame
retardant material. All duct work outside of the
structure must be insulated and weatherproofed in
accordance with local codes.
11. Access and service clearances for the unit must be
Table 2. Lifting and Rigging
Table 3. Curb Dimensions
This drawing was prepared by the manufacturer in order to provide detail regarding job layout only. This drawing is not intended to be used as a
basis to construct, build or modify the item depicted in the drawing. The manufacturer is not responsible for the unauthorized use of this
drawing and expressly disclaims any liability for damages resulting from such unauthorized use.
18-BB35D1-16B-EN
Base of unit
Drip lip on
rest on top of
perimeter of
curb rails
unit
Spreader Bars
Gasket Seal
given careful consideration when locating the duct
entrance openings. "Determine Unit
Clearances," p. 7 provide unit dimensions.
12. Continue with the following installation sections:
Ductwork, Filter and Electrical Wiring.
Drip Lip
BAYLIFT002A
Dimple Lifting Lugs
U U n n i i t t I I n n s s t t a a l l l l a a t t i i o o n n
13