Location - Scotsman NM650R Service Manual

NM650R
FOR THE INSTALLER

Location

Typical Storage Bin with Extension and Bin Top
After uncrating and inspection, the unit is
ready for installation. It is important that the
machine be installed in a location where it has
enough space around it to be accessible for
service, usually a minimum of 6 inches. Try to
avoid hot, dirty and crowded locations. Be
sure that the location for the machine is within
the limitations described on page 3.
Storage Bin
Tip the storage bin on its back, using parts of
the carton to protect the exterior finish. Install
the legs into the threaded holes in the bottom
of the bin. Turn the leg levelers all the way in
preparation for leveling later. Return the bin to
the upright position, remove paper covering
the bin gasket.
Install the bin top according to the directions
with the bin top.
Note: Do not push bin into position, but lift it
there. Pushing a bin, especially one with ice in
it, can cause damage to the legs and the leg
mounts.
Ice Maker
The machine is heavy, so the use of a
mechanical lift is recommended for lifting the
machine high enough to install on top of the
bin. After the unit is placed on the bin, line it
up so it is even with the back side. Secure the
machine to the bin with the hardware provided
with the machine.
Remove the front panel and remove any
shipping blocks.
Note: Be sure to allow a 6" minimum space
above the top of the machine for service.
December, 1988
Page 5