Table of Contents
Advertisement
NM1852
REMOVAL AND REPLACEMENT
Removing Condenser Fan Motor Assembly
/////////////////////////////WARNING//////////////////////////
Disconnect all electrical power to the machine
before beginning.
/////////////////////////////////////////////////////////////////////////
1. Remove the top panel.
2. Unplug the two fan motor wire leads from the
fan motors.
3. Remove two hex head bolts from top end of fan
motor assembly, (see the illustration).
LOCATING
PINS
4. Lift up, and pull out the fan motor assembly.
5. Repair as needed.
6. To reassemble: Place the fan motor assembly
lower flange holes over the two allen head cap
screws in the base, and reinstall the hex head
bolts at the top of the assembly. Plug the fan
motors back in, and replace the top panel.
CAP SCREWS
FAN
MOTOR
WIRE
August 1993
Page 30
FAN MOTOR
ASSEMBLY
Advertisement
Table of Contents
