Ice Diverter Kit - Scotsman ID150 Service Manual

ICE DIVERTER KIT

NOTE: For dispensing Scotsman Nugget Ice:
1. Disconnect power to dispenser.
2. Remove Merchandiser from dispenser.
3. Remove ice chute and discard gate restrictor.
4. Install ice diverter on gate mounting plate as
shown below.
5. Apply RTV to back surface of ice diverter, to seal
to gate mounting plate.
6. Reinstall gasket and ice chute.
7. Reinstall merchandiser and energize unit.
ID150, ID200, ID250
Note: The agitation timer must be adjusted to the
MINIMUM position when dispensing nugget ice.
The timer is located in the electrical box. There
are two items to adjust. One is the Motor On
Time. Set that to the minimum of one half
second. The other is the Off Time. Set that to the
Maximum of 3 hours.
Check the label in the electrical box to confirm
these procedures:
·
Rotate the Motor On Time adjustment fully
CCW to get the half second setting.
·
Rotate the Off Time adjustment fully CW to
get the 3 hour setting.
May 2002
Page 7