Table of Contents
Advertisement
NME1854 & FME2404
REMOVAL AND REPLACEMENT: Water Seal
To Remove the Water Seal:
(Assuming all steps to remove the auger have been
performed.)
1. The gear motor/evaporator assembly will have to
be exposed.
2. Remove the 4 hex head cap screws holding the
evaporator to the gear motor assembly. Lift the
evaporator up and off of the gear motor.
3. Remove the snap ring or wire retainer from the
grove under the water seal.
4. Pull or drive out the lower half of the water seal.
REMOVAL OF THE WATER SEAL
To Replace the Water Seal:
1. Lubricate the water seal with water, and push the
water seal into the bottom of the evaporator slightly
past the grove for the snap ring.
2. Replace the snap ring and pull the water seal
down against it.
3. The part of the water seal that rotates with the
auger must also be replaced. Remove the old part
from the auger and clean the mounting area.
4. Place a small bead of food grade silastic sealant
(such as 732 RTV or Scotsman part number
19-0529-01) on the area of the auger where the
water seal is to be mounted.
5. Carefully push the water seal (rubber side
WATER SEAL
against the auger shoulder and the silastic).
RETAINING
Do not get any silastic onto the face of the seal.
RING
6. Allow the auger and seal to air dry until the
silastic is dry on the surface.
7. If the original water seal was leaking, it would be
a good idea to inspect the interior of the gear motor.
January 2000
Page 28
REPLACING THE
WATER SEAL
PLACE FOOD GRADE
SEALANT HERE
CAUTION
Advertisement
Table of Contents
