Step 1.
Disconnect the battery pack cable from the system board. Then, remove one screw and remove
the solid-state drive and bracket by pulling them away from the slot.
Attention: Use your fingernail to pull the connector to unplug it. Do not pull the cable.
Figure 5. Remove one screw and the solid-state drive and bracket
Screw specifications
M2 × L2
Step 2.
Remove one screw and then remove the solid-state drive bracket.
Figure 6. Remove one screw and the solid-state drive bracket
Screw specifications
M2 × L2
30
Yoga 6 (13", 8) Hardware Maintenance Manual
Number of screws
1
Number of screws
1