Removal And Replacement: Water Reservoir & Bin Controls - Scotsman FME1200R Service Manual

NME950R & FME1200R
REMOVAL AND REPLACEMENT: Water Reservoir & Bin Controls
WATER RESERVOIR
1. Shut off the water supply to the ice maker.
2. Remove front panel and reservoir cover.
3. To remove float only, disconnect water inlet
compression fitting at reservoir inlet.
4. Push in the tab behind the reservoir and pull the
valve assembly up and out of the reservoir tank.
5. To remove reservoir, remove drain hose from
reservoir.
6. Remove evaporator inlet hose from reservoir.
7. Remove mounting screws from reservoir
bracket, and remove reservoir from ice maker.
8. Reverse to reassemble.
SLIDE BIN
CONTROLS IN
AND OUT
FLOAT
ASSEMBLY
ICE
CHUTE
BIN CONTROLS (Ice Level Sensors)
1. Disconnect electrical power.
2. Remove front panel.
3. Remove control box cover.
4. Locate ice chute, at the base of the chute, in
front of and behind it are two plastic bin control
mounts.
5. Slide each bin control to the left, and in the
control box, disconnect the electrical leads
connecting the bin control to the circuit board.
6. Reverse to reassemble, be certain that the bin
controls are aligned so that the ice level sensors
are visible (centered) through the holes in the ice
chute.
December 1995
Page 28
Locking Tabs