Remove The 2280 Solid-State Drive (Ssd); M1.6 X L1.7; Make Sure The Following Frus (Crus) Have Been Removed; Remove The Lower Case - Lenovo Yoga Pro 7 Hardware Maintenance Manual

Screw specifications

M1.6 x L1.7

Step 3. Remove one screw and then remove the SSD bracket from the SSD.
Figure 6. Remove the SSD bracket
Screw specifications
M1.6 x L1.7
Step 4. Remove the SSD mylar.
Figure 7. Remove the SSD mylar
Go to
https://support.lenovo.com/partslookup
replacement parts:
2242 Solid-state drive (SSD)
Solid-state drive (SSD) mylar
Solid-state drive (SSD) bracket

Remove the 2280 solid-state drive (SSD)

Make sure the following FRUs (or CRUs) have been removed.
"Remove the lower case" on page 26
Step 1. Disconnect the battery pack cable from the system board.
Attention: Use your fingernails to pull the connector to unplug it. Do not pull the cable.
Step 2. Remove one screw and then remove the SSD by pulling it away from the slot.
Number of screws
1
Number of screws
1
to look up the Lenovo part numbers of the following
.
Chapter 4 Removing a FRU or CRU
29