Advertisement
LCD language
settings
Platen glass
protection sheet
(document pressure
sheet) position
adjustment
LF / Eject correction
(manual)
Carriage rail position
adjustment
Disc label print
position adjustment
N Capacitive sensor
sensitivity setting
N: New adjustment item
*1: Only for disc label printing supported regions.
To set the language to be displayed
on the LCD.
Not necessary when the machine is
set to the default at shipment from
the production site (On arrival at
user's, the user is to set the language
during setup.).
- At logic board replacement
To maintain scanning accuracy, hold
the sheet with the long side down,
then fit its upper left corner to the
platen glass reference mark (back
left).
- At protection sheet replacement
- At FAU protection sheet
replacement
- At document pressure plate unit
replacement
- At scanner unit replacement
To correct line feeding.
- At paper feed roller replacement
- At platen unit replacement
- At logic board replacement
- At LF / EJ slit film replacement
- At timing slit film replacement
To set the carriage rail to the original
position prior to removal or
replacement of the carriage unit, put
a mark on the main chassis before
removal of the carriage unit.
To set the center of disc label
*1
printing.
- At logic board replacement
- When printing shifts from the
correct position
To correct variation in sensitivity of
the capacitive sensors.
- At logic board replacement
- At document pressure plate unit
replacement
- When user complaints about the
sensitivity of the operation panel
arise
Set the language in the user
mode.
Service Tool
(1) In the Print section,
click LF/EJECT.
(2) According to the printed
pattern, set the
correction value in the
LF / EJECT
Correction section.
Put a mark using a sharp-
pointed metallic stick, such
as a wimble.
Service Tool
CD-R Correction section
Service Tool
Panel Rank section
43 / 66
1 min.
1 min.
*2
5 min.
,
1 min.
*2
Varies
,
depending
on the
degree of
print shift.
*2
5 min.
,
Advertisement
