Appendix B. Troubleshooting
Frequently asked questions and common problems that may occur while using the system are explained in this section. Observe
the following table containing a list of symptoms and the actions to take to solve the problems.
If a problem persists after performing the following actions, contact technical support.
Symptom
No picture is displayed
The module is blinking
The module cannot light up
Possible cause and corrective action
•
The power cable is disconnected.
> Re-connect the power cable.
•
The signal cable is disconnected.
> Re-connect the signal cable.
•
The main switch on the power distribution box is off.
> Make sure the power distribution box is switched on.
•
The LED display controller is off.
> Inspect whether the power connection is correct and the switch has been turned on.
> Inspect whether the LED display controller output has signal and shows blank screen.
> Check whether the mode and parameter of screen configuration are correct.
> Check whether there is image input in input channel and whether it is correctly displayed.
> Check the cable connection between the cabinet and power distribution box, and ensure the
connection is secure.
> Check the cable connection between the cabinet and power distribution box, and ensure the
connection is secure.
25
22BDL7224L