Table of Contents
Advertisement
Troubleshooting
The following table contains the common problems and the solutions to these
problems. Please check this list before you contact the technicians.
Problems
Connect power cord correctly.
Turn on power.
NO PICTURE
Connect video cable correctly.
Select the input signal source with proper cable connection with
the source button.
ABNORMAL
Match the colors on the cables to the ports off the back of the
COLORS
television. I.E. red cable to red colored port.
PICTURE IS TOO
Adjust your contrast, brightness and lamp settings from the
DARK
OSD Menu. For adjust controls, refer to page 27.
AUDIO ONLY NO
Make sure you have connected both your video and audio
PICTURE
cables.
The TV's tuner signal must not be lower than 65 %.
PICTURE ONLY NO
Make sure the audio cable is connected.
AUDIO
Readjust your volume via the remote control.
The TV's tuner signal must not be lower than 65 %.
Turn off the TV, unplug it from the socket. Remove the
batteries out of the remote for 30 minutes. Press the remote
REMOTE CONTROL
buttons and the power button randomly for a good 2 seconds,
DOES NOT WORK
and then reinstall the batteries. Try the remote to see if it
works. For battery removal instructions, refer to page 13.
The TV's remote sensor is also housed in the same place as
the power indicator light. Please make sure there is line of sight
from the remote control's front sensor to the remote sensor of
the TV.
CANNOT RECEIVE
The TV's tuner signal must not be lower than 65 %. Change
SUFFICIENT
the direction of your antenna and rescan your channels. If you
CHANNELS
have cable call up your cable company and ask about signal
THROUGH THE
strength of your local cable.
ATSC/NTSC TUNER
Please adjust your picture setup and make sure the saturation
NO COLOR
and the RGB are not turned all the way down. For adjustment
controls refer to page 27.
The TV's tuner signal must not be lower than 65 %. Check your
signal.
WEAK SIGNAL OR
The TV's tuner signal must not be lower than 65 %. Change
NO PROGRAM
the direction of your antenna and rescan your channels. If you
SYMBOL ON
have cable call up your cable company and ask about signal
SCREEN
strength of your local cable.
TV'S UNIVERSAL
This television follows SONY's universal remote code. To
REMOTE CODE
find the actual code you must read through your own
universal remote's guide boENTER.
Solutions
- 45 -
www.SCEPTRE.com
SCEPTRE X42 HDTV User Manual
Advertisement
Table of Contents
