Table of Contents
Advertisement
TROUBLESHOOTING
You cannot activate the appliance.
The drum does not rotate.
The programme does not start.
The appliance door does not close.
The appliance stops during operation.
The cycle time is too long or unsatisfactory dry-
1)
ing result.
The display shows
1) After maximum 5 hours, the programme ends automatically.
2) It can happen that some area remains humid when drying big items (e.g. bed sheets ).
If the drying results are not satisfactory
•
The set programme was incorrect.
•
The filter is clogged.
•
The Heat Exchanger is clogged.
•
There was too much laundry in the appliance.
•
The drum is dirty.
•
Incorrect setting of the conductivity sensor
( See chapter "Settings - Adjustment of the
Problem
.
Possible solution
Make sure that the mains plug is connected to
the mains socket.
Check fuse in fuse box (domestic installation).
Release the rear drum locks manually (see chap-
ter Before First Use).
Press Start/Pause.
Make sure that the appliance door is closed.
Make sure that the installation of the filter is cor-
rect.
Make sure that the laundry is not caught be-
tween the appliance door and the rubber seal.
Make sure that the water container is empty.
Press Start/Pause to start the programme again.
Load is too small, increase the load or use the
Time Dry programme.
Make sure that the weight of the laundry is suita-
ble for the duration of the programme.
Make sure that the filter is clean.
The laundry is too wet. Spin the laundry in the
washing machine again.
Ensure that the room temperature is higher than
+5°C and lower than +35°C. Optimal room tem-
perature is 18°C to 25°C.
Set the Time Dry or the Extra Dry programme.
If you want to set a new programme, deactivate
and activate the appliance.
Make sure that the options are suitable for the
programme.
remaining laundry moisture degree " for better
setting).
•
The airflow slots are clogged.
•
Room temperature is too low or too high
( optimal room temperature 18°C to 25°C )
2)
19
Advertisement
Table of Contents
