Table of Contents
Advertisement
3-3-2. CASSETTE DRIVE GEAR (See Fig.3-3-3)
1) Refer to section 3-3-1 and remove the cassette mecha-
nism assembly.
2) Remove clamps
holder
.
3) Remove the clamp
4) Remove the clamp
ASSEMBLY NOTES:
1. Put the tray in the EJECT mode position before fitting
any parts.
2.
Apply grease (VHJ-0100) to the gear mounting shafts,
all the gear teeth, and the cam part of the drive gear
.
3. Ensure that the drive gear, the lock gear and the
pinion gear interlock correctly, as shown in Fig.3-3-2.
4. Make sure the clamps
holder
.
Tray
Drive gear
Lock gear
(grease the outer rim
of the teeth)
and
, then remove the gear
, then remove the pinion gear
, then remove the lock gear
and
snap in to the gear
Apply
grease
Pinion gear
(grease the
outer rim of
the teeth)
Clamp
Clamp
Gear holder
Fig.3-3-3
3-3-3.DOOR OPENER, UNDER FRAME AND
STAND L (See Fig.3-3-4)
1) Remove the cassette mechanism assembly, referring
to section 3-1.
2) Remove the two clamps
.
frame
, pulling it towards you.
.
3) Press down the tray lock lever
lever
, and loosen the tray
you. In this state, press the clamp
door opener lever
4) Remove the special washer
washer
.
5) Remove the two clamps
Be careful not to exert too much force on the clamps
, as this could cause damage.
ASSEMBLY NOTES:
1. Apply grease (VHJ-0100) to the grooves
stand L, the inside of the hole
and the mounting hole
the stand R.
2. Before fitting the stand L
tray
back as far as the EJECT mode position. Put
the two pins
the stand L. Put the drive shaft
3. Be sure to fasten the two clamps
on the stand R, and to fasten the two clamps
the stand L.
Stand L
Grooves
Special
washer
Washer
Hole
Pins
Clamp
Drive
shaft
Door opener
lever
Under frame
–10–
and take out the under
and the lid opener
, lifting it away from
and remove the
.
, then remove the
and take out the stand L
in the drive shaft
in the door opener lever of
, be sure to move the
on the tray
into the grooves
into the hole
and the clamp
Tray
lock lever
Tray
Clamp
Hole
Clamp
.
on the
,
on
.
on
Lid opener
lever
Clamps
Stand R
Fig.3-3-4
Advertisement
Table of Contents
