Gigabyte H310M S2V User Manual page 15

6) F_PANEL (Front Panel Header)
Connect the power switch, reset switch, speaker, chassis intrusion switch/sensor and system status indicator
on the chassis to this header according to the pin assignments below. Note the positive and negative pins
before connecting the cables.
Power LED Power Switch
2 10
1 9
Hard Drive Reset Switch
Activity LED
• RES (Reset Switch):
Connects to the reset switch on the chassis front panel. Press the reset switch to restart the computer
if the computer freezes and fails to perform a normal restart.
• NC: No connection.
The front panel design may differ by chassis. A front panel module mainly consists of power switch, reset
switch, power LED, hard drive activity LED, speaker and etc. When connecting your chassis front panel
module to this header, make sure the wire assignments and the pin assignments are matched correctly.
7) F_AUDIO (Front Panel Audio Header)
The front panel audio header supports High Definition audio (HD). You may connect your chassis front
panel audio module to this header. Make sure the wire assignments of the module connector match the
pin assignments of the motherboard header. Incorrect connection between the module connector and the
motherboard header will make the device unable to work or even damage it.
9 1
10 2
Some chassis provide a front panel audio module that has separated connectors on each wire instead
of a single plug. For information about connecting the front panel audio module that has different wire
assignments, please contact the chassis manufacturer.
• PLED (Power LED):
Connects to the power status indicator
System Status LED
on the chassis front panel. The LED is on
S0 On
when the system is operating. The LED is
S3/S4/S5 Off
off when the system is in S3/S4 sleep state
or powered off (S5).
• PW (Power Switch):
Connects to the power switch on the chassis front panel. You may
configure the way to turn off your system using the power switch (refer
to Chapter 2, "BIOS Setup," "Power," for more information).
• HD (Hard Drive Activity LED):
Connects to the hard drive activity LED on the chassis front panel. The
LED is on when the hard drive is reading or writing data.
Pin No. Definition Pin No. Definition
1 MIC2_L 6
2 GND 7
3 MIC2_R 8
4 NC 9
5 LINE2_R 10
- 15 -
Sense
FAUDIO_JD
No Pin
LINE2_L
Sense