Table of Contents
Advertisement
Connections
Side AV Connections
You can connect a range of optional equipment to
your LCD TV.
For connecting a camcorder, connect to the
1.
VIDEO IN socket and the AUDIO SOCKETS. Do
not connect the camcoder to VIDEO IN socket
at the same time since it can cause noise in the
picture. For selecting the related source, see the
section "Input selection" in the following parts
.
(fig.1)
To listen the TV sound from headphones,
2.
connect to the HEADPHONE jack of theTV.
Using a Conditional Access Module
IMPORTANT: Insert or remove the CI module only
when the TV is SWITCHED OFF.
In order to watch certain digital channels, a conditional
access module (CAM) can be necessary. This module
must be inserted in the CI slot of your TV.
1. Obtain the Conditional Access Module (CAM) and
the viewing card by subscribing to a pay channel
company, then insert those to the TV using the following
procedure.
2. Insert the CAM and then the viewing card to the slot
that is located in the terminal cover at the rear side of
the TV.
3. The CAM should be correctly inserted, it is impossible
to insert fully if reversed. The CAM or the TV terminal
may be damaged if the CAM is forcefully inserted.
4. Connect the TV to the mains supply, switch on and
then wait for few moments until the card is activated.
5. When no module is inserted, "No Common Interface
module detected" message appears on the screen.
You can refer to the module instruction manual for
details of the settings.
For any help concerning set up and use of your TV please call the Customer Helpline: 0345 604 0105
AVCable
(notsupplied)
Camera
fig. 1
fig. 2
Headphone
CAM
module
21
Advertisement
Table of Contents
