Table of Contents
Advertisement
You can select Network, Frequency, Network
ID and Search Step from this screen. For
highlighting lines you see, use Up or Down button.
You can set Search Step as 8000 kHz or 1000
kHz. If you select 1000 kHz, the TV will perform
search process in a detailed way. Searching
duration will thus increase accordingly. When
finished, press OK button to start automatic
search.
If you select NO, the following screen will be
displayed:
You can set Start - Stop Frequencies and Search
Step as desired. When finished, press OK button
to start the search.
9. If you select Aerial option from the Search Type
screen, a confirmation message will be displayed.
If you want to continue with searching select Yes,
the television will search for available broadcasts.
Select No to exit.
10. The Auto tuning screen will appear and the
television will start to search for available stations.
The progress bar will move along the line. You
must allow the television to complete the search.
Initial Installation -
English - 15 -
continued
Note: You can press MENU button to cancel.
11. If you select Satellite option from the Search Type
screen, Antenna Type menu will be displayed.
There are three types of antenna selection. You
can select Antenna type as Direct, Unicable
or DiSEqC.
Direct: If you have a single receiver and a direct
satellite dish, select this antenna type. After selecting
Direct, another menu screen will be displayed.
Select an available satellite and press GREEN
button to scan for services.
Unicable: If you have multiple receivers and a
unicable system, select this antenna type. Press
OK to continue. Configure settings by following
instructions on the screen. Press GREEN button
to scan for services.
DiSEqC switch: If you have multiple satellite
dishes and a DiSEqC switch, select this antenna
type. After selecting DiSEqC switch, another
menu screen will be displayed. You can set four
DiSEqC options (if available). Press GREEN
button to scan all satellites or press YELLOW
button to scan only the highlighted satellite. To
save and exit press OK button.
SatcoDX Preset List: When you start a search
a message will appear asking whether you want
to load preset list or not. This function is correct
for countries Germany and Austria. For other
countries select No and channel order will be
applied if applicable.
SartcoDX allows the user to upload a preset list
if supported by the broadcaster. See Satellite
Settings section.
Advertisement
Table of Contents
