Table of Contents
Advertisement
Terminals Features
1. COMPUTER IN (Mini D-Sub 15 Pin)
(→ page 14, 145, 151, 175)
2. DisplayPort IN Terminal (DisplayPort 20 Pin)
(→ page 146, 175)
3. HDMI IN Terminal (Type A)
(→ page 146, 148, 152, 175)
4. BNC IN [R/Cr/CV, G/Y/Y, B/Cb/C, H, V] Terminals
(BNC × 5)
(→ page 145, 150)
5. BNC (Y/C) Input Terminal (BNC × 2)
(→ page 150)
6. BNC (CV) Input Terminal (BNC × 1)
(→ page 150)
7. USB Port (Type A)
(→ page 176)
(For future expansion. This port allows for power sup-
ply.)
8. HDMI OUT Terminal (Type A)
(→ page 149)
9. Ethernet/HDBaseT Port (RJ-45)
(→ page 153, 154, 176)
10. 3D SYNC Terminal (Mini DIN 3 Pin)
(→ page 48)
11. PC CONTROL Port (D-Sub 9 Pin)
(→ page 176, 183)
Use this port to connect a PC or control system.
This enables you to control the projector using serial
communication protocol. If you are writing your own
program, typical PC control codes are on page 183.
8
9
14
12
11
3
2
1
6
13
10
12. REMOTE Terminal (Stereo Mini)
Use this jack for wired remote control of the projector
using a commercially available remote cable with ⌀3.5
stereo mini-plug (without resistance).
Connect the projector and the supplied remote control
using a commercially available wired remote control
cable.
(→ page 12)
NOTE:
• When a remote control cable is connected to the REMOTE
terminal, infrared remote control operations cannot be per-
formed.
• Power cannot be supplied from the REMOTE terminal to the
remote control.
• When [HDBaseT] is selected in the [REMOTE SENSOR]
and the projector is connected to a commercially-available
transmission device that supports HDBaseT, remote control
operations in infra-red cannot be carried out if transmission
of remote control signals has been set up in the transmission
device. However, remote control using infrared rays can be
carried out when the power supply of the transmission device
is switched off.
13. SLOT
(→ page 165)
14. Service terminal
For service only
9
1. Introduction
7
4
5
Advertisement
Table of Contents
