Connecting To The Computer - Sanyo PLC-XU10N Owner's Manual

CONNECTING THE PROJECTOR
CONNECTING TO THE IBM-COMPATIBLE COMPUTER
To connect with the IBM-compatible computer, refer to the figure below.
Use Cables and Adapter indicated below.
· VGA CABLE (supplied)
· MOUSE CABLE FOR PS/2 PORT or SERIAL PORT (supplied)
· MCI SERIAL CABLE (supplied)
· MONITOR CABLE (not supplied)
· AUDIO CABLE (stereo /not supplied)
Be sure to connect the MOUSE CABLE corresponding with the terminal of your computer.
NOTE :
When connecting the cable, the power cords of both the projector and the external equipment should be
disconnected from AC outlet. Turn the projector and peripheral equipment on before the computer is switched
on.
IBM-COMPATIBLE COMPUTERS (VGA / SVGA / XGA / SXGA)
Desktop type
To the Monitor
12
Monitor
Monitor Output Serial port
VGA Cable (supplied)
Monitor Cable (not supplied)
Laptop type
To each terminal of your computer
Serial port PS/2 port Audio Output
Terminal Terminal
Mouse Cable for Serial Port (supplied)
MCI Serial Cable (supplied)
Audio Speaker
(stereo)
Audio Amplifier
Audio Input
Audio Cable
(stereo / not supplied)
Mouse Cable for PS/2 Port (supplied)