Draadloze Kaart; De Draadloze Kaart Verwijderen - Dell OptiPlex Small Form Factor 7010 Owner's Manual

Hide thumbs Also See for OptiPlex Small Form Factor 7010:
Table of Contents

Advertisement

Available languages

Available languages

NOTE:
The thermal pad is re-usable. The thermal pad is pre-installed on systems shipped with solid-state drive. If the
solid-state drive is purchased separately, the thermal pad is not bundled with the solid-state drive kit and is to be
purchased separately.
2. Peel off the protection mylar on the thermal pad.
3. Align the notch on the M.2280 solid-state drive with the tab on the M.2 card slot on the system board.
4. Slide the M.2280 solid-state drive into the M.2 card slot on the system board.
5. Replace the screw (M2x3.5) to secure the M.2280 solid-state drive to the system board.
Next steps
1. Install the
disk-drive
cage.
2. Install the
3.5-inch hard drive
3. Install the
2.5-inch hard drive
4. Install the
front
bezel.
5. Install the
side
cover.
6. Follow the procedure in

Draadloze kaart

De draadloze kaart verwijderen
Vereisten
1. Volg de procedure in
Voordat u in de computer gaat
2. Verwijder de zijplaat.
3. Verwijder het montagekader.
4. Verwijder de
2,5 inch harde
5. Verwijder de
3,5 inch harde
6. Verwijder de
behuizing van de harde
Over deze taak
De volgende afbeelding geeft de locatie van de draadloze kaart aan en biedt een visuele weergave van de
verwijderingsprocedure.
60
CRU's (door de klant zelf te vervangen onderdelen) verwijderen en installeren
if applicable.
if applicable.
After working inside your
schijf, indien van toepassing.
schijf, indien van toepassing.
schijf.
computer.
werken.

Advertisement

Table of Contents
loading

This manual is also suitable for:

D17s

Table of Contents