HP 3100-48 v2 Installation Manual page 26

Table of Contents

...............................................................................

.....................................Done!

System is starting...

Board checking.......................LSJ252TPA

SDRAM fast selftest........................OK!

Flash fast selftest........................OK!

CPLD selftest..............................OK!

Switch chip selftest.......................OK!

PHY selftest...............................OK!

Please check leds....................FINISHED!

User interface aux0 is available.

Press ENTER to get started.

Press Enter at the prompt, and you can configure the switch when the prompt <HP> appears.

NOTE:

For more information about the configuration commands and command line interface, see the

3100-48 v2 Switch Configuration Guides

HP 3100-48 v2 Switch Command References

and the

Table of Contents