Summary of Contents for Tiger TYAA211
- Page 1 User Instruction Manual Dual Sliding Beam Anchor Model # TYAA211 Model # TYAA212 Model # TYAA213 MANUFACTURED BY: Woo Sing Industrial Co., Ltd No 20 Yunong Road Shih-lin Taipei Taiwan Phone: +886-2-2831 3035 Fax: +886-2-2834 0188 info@tigerlifting.com.tw...
-
Page 2: Table Of Contents
Table of Contents Warning and Important Notification Dual Sliding Beam Anchor Components Specifications Applications Installation and Use Training Inspection Maintenance, Service, Storage Inspection and Maintenance Log... -
Page 3: Dual Sliding Beam Anchor Components
WARNING: This product is to be used as part of a personal fall protection system. The user must read the manufacturer’s instruction and be familiar with each component of the equipment. The user must fully understand this instruction and to be trained before using this equipment. -
Page 4: Specifications
SPECIFICATIONS Dimensions: Beam Size Range, Model TYAA211: 12-in. (305mm) Maximum 2.5-in. (63.5mm) Minimum Model TYAA212: 18-in. (457mm) Maximum 2.5-in. (63.5mm) Minimum Model TYAA213: 24-in. (610mm) Maximum 2.5-in. (63.5mm) Minimum Flange Thickness, Model TYAA211: 1.5-in.(38mm) Maximum Model TYAA212: 1.5-in. (38mm) Maximum Model TYAA213: 1.5-in. - Page 5 When a free fall greater than 6 feet and up to a maximum of 12 feet if possible, Tiger recommends using a personal fall arrest system incorporating with an energy absorbing lanyard.
- Page 6 Fall Clearance Diagram Personal Fall Arrest System: The Dual Sliding Beam Anchor is designed for use with Tiger approved components or CE/ANSI certified components. Use of this equipment with non-approved components may result in incompatibility between equipment, and could affect the reliability and safety of the complete system.
-
Page 7: Installationand Use
INSTALLATIONAND USE Installation configuration: Bottom Mount Top Mount Inspect the equipment according to INSPECTION of this manual before each use. The Dual Sliding Beam Anchor could only be installed on any I-beam for horizontal position, and located on the bottom and top of the I-beam. Step 1. -
Page 8: Training
Step 4. Record the inspection date and results in the INSPECTION AND MAINTENANCE LOG. If inspection reveals an unsafe or defective condition, remove the equipment from service and destroy, or return to Tiger for repair. NOTE: Only Tiger or parties authorised in writing are qualified to repair this equipment. MAINTENANCE, SERVICE, STORAGE Cleaning: Periodically clean the Dual Sliding Beam Anchor by water and a mild soap solution. -
Page 9: Inspectionand Maintenance Log
INSPECTIONAND MAINTENANCE LOG Company: Location: Date Purchased: Serial Number: Model Number: No Changes By a No Missing Functioning Year Date Qualified No Corrosion Parts Deformation Condition Attachment Person Structure Maintenance Corrective Action Performed Maintenance Corrective Action Performed Maintenance Corrective Action Performed Maintenance Corrective Action...