Viewing The Various Functions On Your System; Setting The Clock - Samsung MM-ZB7 Instruction Manual

Viewing the Various Functions on
Your System
GB
You can view the various functions available on your system.
1
Press the Demo button.
Result: The various functions available are listed in turn on the
display.
All these functions are described in detail in this booklet.
For instructions on how to use them, refer to the appropriate
sections.
2
To cancel this function, press Demo again.
TUNER TUNER TUNER
Band Band
Down Down
CD CD
TAPE TAPE
AUX AUX
Rec/Pause Rec/Pause
10
Open/Close Open/Close
Tuning Tuning
Up Up
Mode Mode
Demo/Display
Demo
Volume Volume
Sound Sound
MIC
Mode Mode
REV.Mode REV.Mode

Setting the Clock

Your system is equipped with a clock which allows you to
turn your system on and off automatically.
You should set the clock:
When you first purchase the micro component system
After a power failure
After unplugging the unit
For each step, you have a few seconds to set the required
options. If you exceed this time, you must start again.
1
Switch the system on by pressing Standby/On (
2
Press Timer/Clock twice.
Result: CLOCK is displayed.
3
Press Program/Set.
Result: The hour flashes.
4
To...
Increase the hours
Decrease the hours
5
When the correct hour is displayed, press Program/Set.
Result: The minutes flash.
6
To...
Increase the minutes
Decrease the minutes
When the correct time is displayed, press Program/Set.
7
Result: The clock starts and is displayed, even when the system is in
standby mode.
You can display the time, even when you are using another
function, by pressing Timer/Clock once.
1
EQ/P.Sound
TAPE
REV.
CD SYNC.
Mode
3,5,7
Repeat
VOL.
Program/
Set
Tune/CD
Mode
4,6
VOL.
) .
Press...
Press...
Timer Timer/
On/Off Clock
2
Sleep Aux
RDS
Display
PTY
CD
+10
Band
4,6