Demo/Dimmer Function; Setting The Clock - Samsung MAX-KDZ100 Instruction Manual

Demo/Dimmer function

GB
All functions available on the system can be viewed on the
display and the display's brightness can be switched between
"on" and "off".
1
Press the Demo/Dimmer button.
Result: All functions available on the system appear on the front
panel display.
Each of these are explained in detail in this guide. Please refer to
the relevant section.
2
Press the Demo/Dimmer button again.
Result: The Dimmer function is selected and the display darkens.
3
Press the Demo/Dimmer button once again to brighten the front
panel display.
A display brightness control can only be performed while the
system power is on.

Setting the Clock

Your system is equipped with a clock which allows you to
turn your system on and off automatically. You should set the
clock:
When you first purchase the Mini Component System
After a power failure
After unplugging the unit
For each step, you have a few seconds to set the required
options. If you exceed this time, you must start again.
1
Switch the system on by pressing Standby/On button.
2
Press the Timer/Clock button twice.
Result: CLOCK is displayed.
3
Press the Enter button.
Result: The hour flashes.
4
To...
Increase the hours
Decrease the hours
5
When the correct hour is displayed, press the Enter button.
Result: The minutes flash.
6
To...
Increase the minutes
Decrease the minutes
7
When the correct time is displayed, press the Enter button.
Result: The clock starts and is displayed, even when the system is in
P
You can display the time, even when you are using another
function, by pressing Timer/Clock button once.
You can also use
in step 4, 6.
1
Turn the Multi Jog knob to the...
Right
Left
Turn the Multi Jog knob to the...
Right
Left
standby mode.
buttons to instead Multi Jog knob
2
4,6
GB
P
3,5,7
12