Table of Contents
Advertisement
NoLAMI(Facedown) ... Ejects the card back side up without any lamination.
NoLAMI(Through) ... Ejects the card back side up without any lamination.
NoLAMI(Flip) ... Ejects the card front side up without any lamination.
"No data" is shown when the setting has not yet been configured.
Adjust Speed
The Adjust Speed menu displays the Laminator's current lamination speed. The lamination speed
can be set from this menu. The 1
configured separately. The default speed is 10 and it can be set between the range of 0 to 20.
Lowering the number will decrease lamination speed and increasing the number will increase
lamination speed.
Adjust TEMP
The Adjust TEMP menu displays the Laminator's current temperature setting. The lamination
temperature can be set from this menu. The 1
lamination temperature can be configured separately. The default temperature is 12 and it can be
set between the range of 0 to 20. Lowering the number will decrease the lamination temperature
and increasing the number will increase the lamination temperature.
Adjust Position
The Adjust Position menu displays the Laminator's current lamination position offset.
The lamination position offset can be set from this menu. The default position offset is 10 and it
can be set between the range of 0 to 20. Lowering the number will move the laminated patch up
towards the leading short edge of the card. Increasing the number will move the laminated patch
down towards the trailing short edge of the card.
7
st
side lamination speed and 2
st
side lamination temperature and 2
IX-R7000 Card Lamination Module Configuration Guide
nd
side lamination speed can be
nd
side
Advertisement
Table of Contents
