Dell Latitude 9520 2-in-1 Service Manual page 42

About this task
The following image indicates the location of the battery and provides a visual representation of the installation procedure.
NOTE: If battery was disconnected from system board for service, there will be a delay during system boot-up as the
system will undergo RTC battery reset.
Steps
1. Align and place the battery on the palmrest and keyboard assembly.
2. Replace the single (M1.6x3.5) screw and four (M2x3) screws to secure the battery in place.
3. Reconnect the battery cable to the connector on the system board.
4. Route the wireless antenna cables on the routing guides and adhere the adhesive tape.
Next steps
1. Install the speakers.
2. Install the base cover.
3. Install the SIM card tray.
4. Install the microSD card.
5. Follow the procedure in
42 Removing and installing components
After working inside your computer.