Husqvarna 522HDR75S Workshop Manual page 37

11. Remove the gasket (A).
A
B
D
G
H
I
J
K
12. Remove the wear plate (B).
13. Remove the seal (C).
14. Remove the connecting rod (D).
15. Remove the 2 screws (E) and the nuts (F).
16. Remove the cutting attachment.
17. Remove the needle bearing (G).
18. Remove the gear wheel (H).
19. Remove the needle bearing (I).
20. Remove the connecting rod (J).
21. Remove the wear plate (K).
1017 - 002 - 25.11.2020
22. Put the clutch drum in the thread holes in the gear
housing to lock in position. Use a gear drive removal
tool to remove the gear drive. Refer to
tools on page 12 .
C
E
23. Push the gear drive out of the ball bearing and
remove the clutch drum from the gearbox housing.
F
24. Remove the ball bearing from the gearbox housing.
7.10.2 To clean and examine the clutch, clutch
drum and gearbox
• Examine the clutch drum for wear.
• Examine all the parts. Replace parts, if it is
necessary.
• Examine the clutch and the clutch springs for
damages.
CAUTION: Install the connection rods with
the text in the direction of the gear wheel.
CAUTION: Replaced or cleaned parts must
be lubricated on all sides. Use Husqvarna
bevel gear grease. Refer to
on page 12 and Servicing data on page 6 .
Repair instructions - 37
Servicing
Servicing tools