D-Link DGS-1210-28X/ME Getting Started Manual page 4

The web configuration can also be accessed through the
DNA. You can click the IP hyper link in the device list in
the DNA to open the web GUI of devices.
NOTE: The switch's factory default IP
address is 10.90.90.90 with a subnet
mask of 255.0.0.0 and a default
gateway of 0.0.0.0
Step 3
When the following logon dialog box appears, leave both
User Name and the Password in blank then click OK.
This will open the Web-based user interface.
Figure 9. Enter Network Password window
DNA (D-Link Network Assistant)
The DNA (D-Link Network Assistant) is a program for
discovering Smart Switches with the same L2 network
segment connected to your PC. This tool can support
windows 2000, XP, Vista, and Windows 7.
Option 1: Follow these steps to install the DNA
via the autorun program on the installation CD
(in case the installation CD is included).
1. Insert the CD into your CD-Rom Drive.
2. The autorun program will pop up automatically
3. Simply click on the "Install DNA (D-Link Network
Assistant)" button and an installation wizard will guide
you through the process.
4. After successfully installing the DNA, you can find it
under Start > Programs > D-Link > DNA.
5. Just connect the Smart Switch to the same L2 network
segment of your PC and use the DNA (D-Link
Network Assistant) to discover the Smart Switches.
Option 2: Follow these steps to install the DNA
manually (in case the installation CD is included).
1. Insert the Utility CD into your CD-Rom Drive.
2. From the Start menu on the Windows desktop, choose
Computer.
3. Double click on your CD-Rom/DVD-Rom Drive to start
the autorun menu, or right click on the Drive to open
the folder. Select DNA (D-Link Network Assistant) and
double click on the setup.exe file.
4. Follow the on-screen instructions to install the utility.
5. Upon completion, go to Start > Programs > D-Link
> DNA and open the DNA (D-Link Network Assistant).
6. Just connect the Smart Switch to the same L2
network segment of your PC and use the DNA (D-Link
Network Assistant) to discover the Smart Switches.
Option 3: (in case the installation CD is not
included).
Download DNA (D-Link Network Assistant) from Google
Play at https://play.google.com/store/apps/ and follow the
on-screen instructions to install the utility.
For detailed information of DNA, please refer the user
manual.
Connecting The Console Port
(depending on the purchased model)
To connect to the serial port, a special Console Cable
must be used. The cable referred to as an RS-232 to
RJ-45 connector cable specifically pinned to connect
to this switch's serial port by using the correct pin
configuration.
To connect to the console port of the Switch, use the
following steps:
1. Connect the RS-232 end of the console cable to the
Serial Port of the management PC.
2. Connect the RJ-45 end of the console cable to the
Console Port of the Switch.
3. Open the HyperTerminal application (or any terminal
emulation program capable of emulating a VT-100
terminal connection) on the management PC and
configure the Properies of this connection.
a.The Bits per second should be 115200 baud.
(baud rate setting depend on purchased models)
b.The Data bits should be 8.
c.The Parity should be None.
d.The Stop bits should be 1.
e.The Flow control should be None.
Figure 10. Hyperterminal Connection Properties
4