Advertisement
Quick Links
MCI-GM53
Introduction and Features
The MCI-GM53 will allow the addition of a reverse, blind spot, and one more additional camera in vehicles equipped
with the 7" screen.
Important Notes
1.
Compatible build code: IOB. Incompatible build codes: IOA, IO4, IO5, and IO6 . Build codes can be found on a silver sticker either in
the glove box or by scanning the QR code in the driver door frame.
2.
If you change the DIP switch settings, you must disconnect and reconnect power for the change to take effect.
3.
It is very important that you make all connections with the key in the off position. Failure to do so will result in the factory
touchscreen becoming unresponsive. If you do make the connections with the key on, you must turn the vehicle off, shut all doors, and
leave it alone for 5 minutes. After 5 minutes, turn the key back on, and the interface should operate as intended.
4.
If you are installing this interface strictly to add a reverse camera, please note that the blind spot inputs will need to be disabled by
entering the menu and manually disabling the inputs (see page 3, step 3 for details).
What's Included
Number
1
2
3
4
5
6
7
Pacific Accessory Corporation
Description
Module
Mounting Bracket
Video Input Harness
VBM Harness
Power Harness
LVDS Harness
Foam Padding/
Mounting Screws
for select General Motors Vehicles
Replacement Part Number
MCI-GM53
GMSWRBRKT
BSM2-CEH
BSM1-TMON-HAR V2
BSM2-PTH
BSM1-LVDS
Miscellaneous
Multi Camera Input Interface
Rev. V2
Page 1
Date: 072419
Advertisement
Summary of Contents for PAC MCI-GM53
- Page 1 Multi Camera Input Interface for select General Motors Vehicles Introduction and Features The MCI-GM53 will allow the addition of a reverse, blind spot, and one more additional camera in vehicles equipped with the 7” screen. Important Notes Compatible build code: IOB. Incompatible build codes: IOA, IO4, IO5, and IO6 . Build codes can be found on a silver sticker either in the glove box or by scanning the QR code in the driver door frame.
- Page 2 (Fig. B) Input Function Connect the MCI-GM53’s gray and gold male plugs on the power harness to the factory tuner unit (Fig. A). Camera 1 Left Camera Connect the factory gray and gold plugs into the female connectors on the MCI-GM53 power harness.
- Page 3 16. If necessary, use the provided foam padding to insulate the module from any rattles before securing inside the dash cavity. 17. Reconnect any leftover harnesses to the dash panel / screen assembly and reinstall. 18. Test for proper operation of the MCI-GM53 following the operation section below. Operation Fig. D...
- Page 4 MCI-GM53 Multi Camera Input Interface for select General Motors Vehicles Operation (cont.) Accessing Installer Setup Fig. G Press and hold the small lock icon in the top right corner of the camera setup menu to access installation settings (Fig. G).