Connect to the video output port on your PC. COMPONENT 2 Connect a component video/audio. COMPONENT 1 Connect a component video/audio. TV ANTENNA Connects to an antenna or to a cable TV system. AUDIO INPUT Connect audio signal(L/R) from a camcorder or VCR.
TV. If you have a “mono” (non-stereo) VCR, use the Y-connector (not supplied) to hook up to the left and right audio input jacks of the TV. If your VCR is stereo, you must con- nect two cables.
N S TA L L AT I O N Connecting an S-VHS VCR Your Samsung TV can be connected to an S-Video signal from an S-VHS VCR. (This connection delivers a better picture as compared to a standard VHS VCR.) To begin, follow steps 1–3 in the...
6/27/03 2:04 AM N S TA L L AT I O N Connecting a DVD Player The rear panel jacks on your TV make it easy to connect a DVD player to your TV. Connect a set of audio cables between the...
N S TA L L AT I O N Connecting a PC Note: This figure shows the Standard Connector-jack panel. The actual configuration on your TV may be different, depending on the model. TV rear panel PC VIDEO INPUT (15-pin D-SUB) •...
Page 6
How to assemble the TV set and stand base Colors may vary depending on the model you purchase NOTE : The curved side of the stand base should be placed at the back of the TV set as shown in the above figure. English-...
Secure the bracket to the wall. Use (a) holes to attach the VESA mount. Use (b) holes to attach the wall mount. Mount the TV on the wall mount bracket. Rubber : 4EA Holder-LCD L/R : 2EA #The wall mount bracket is sold separately.
Note: The maximum tilt angle is 10 degrees in the backward direction. Please do not tilt the TV outside the specified range. Using excessive force to tilt the TV may cause permanent damage to the mechanical part of the stand. Colors may vary depending on the model you purchase...