Connecting An S-Vhs Vcr; Connecting A Dvd Player (480I/480P) - Curtis Mathes CM25020 Owner's Manual

I
N S TA L L AT I O N
Connecting an S-VHS VCR (For model CM25020S)
Your TV can be connected to an S-Video signal from an S-VHS VCR.
(This connection delivers a better picture as compared to a standard VHS VCR.)
1
To begin, follow steps
1–3 in the previous
section to connect the
antenna or cable to your
VCR and your TV.
2
Connect a set of audio
cables between the
AUDIO OUT jacks on the
VCR and the AUDIO
INPUT jacks on the TV.
3
Connect an S-video cable
between the
S-VIDEO OUT jack on the
VCR and the
S-VIDEO INPUT
jack on the TV.
An S-video cable is usually included with an S-VHS VCR. (If not, check your local
electronics store.)

Connecting a DVD Player (480i/480p)

(For models CM27020S/CMF2010S)
The rear panel jacks on your TV make it easy to connect a DVD player to your TV .
1
Connect a set of audio
cables between the DVD-
IN AUDIO IN jacks on the
TV and the AUDIO OUT
jacks on the DVD player.
2
Connect a video cable
between the DVD-IN
(Y, P
and the DVD-OUT (Y, P
P ) jacks on the DVD
R
player.
Note: For an explanation of Component video, see your DVD player's owner's manual.
2.6
C T : I
HAPTER WO NSTALLATION
, P ) jacks on the TV
B R
,
B