Quick Start: Getting Up To Speed - Traxxas BANDIT 24054-4 Owner's Manual

QUICK START: GETTING UP TO SPEED

The following guide is an overview of the procedures for getting your model running. Look for the Quick Start logo on the bottom
corners of Quick Start pages.
1. Read the safety precautions on pages 4-6
For your own safety, understand where carelessness and misuse
could lead to personal injury.
2. Charge the battery pack • See page 15
Your model requires a battery pack and a compatible battery
charger (not included). Never use a NiMH or NiCad charger to
charge LiPo batteries.
3. Install batteries in the transmitter • See page 15
The transmitter requires 4 AA alkaline or rechargeable batteries
(sold separately).
4. Install battery pack in the model • See page 16
Your model requires a fully charged battery pack (not included).
5. Install the antenna • See page 16
The receiver antenna and antenna tube must be properly installed
before operating your model.
6. Turn on the radio system • See page 17
Make a habit of turning the transmitter on first and off last.
7. Check servo operation • See page 18
Make sure the steering servo is working correctly.
8. Range test the radio system • See page 18
Follow this procedure to make sure your radio system works properly
at a distance and that there is no interference from outside sources.
9. Detail your model • See page 12
Install wings (if necessary) and apply other decals if desired.
10. Drive your model • See page 23
Driving tips and adjustments for your model.
11. Maintaining your model • See page 29
Follow these critical steps to maintain the performance
of your model and keep it in excellent running condition.
The Quick Start Guide is
not intended to replace the
full operating instructions
available in this manual.
Please read this entire
manual for complete
instructions on the proper
use and maintenance of
your model.
Look for the Quick Start
logo at the bottom of
Quick Start pages.
TRAXXAS • 11