Bosch SHSM53 Series Quick Start And Safety Manual page 5

USAGE TIPS FOR BEST RESULTS
Use rinse
aid
for better
drying.
Setting Factory setting Description
š-Intensive drying š:‹‹/ off
š:‹‹-š:‹‚
§-Rinse Aid
§:‹†
§:‹‹-§:‹‡
›-Beep at cycle
›:‹ƒ
end
›:‹‹-›:‹„
‚ -Infolight® ‚:‹‚ / on
‚:‹‹-‚:‹‚
˜-Auto power off ˜:‹‹/ unit does
not shut off
˜:‹‹-˜:‹ƒ
automatically
ADJUSTING THE SETTINGS
Press the On/Off button. Hold down button A (see pages 6-7) and press
1.
Start until the display shows š:‹
Release both buttons. The LED for the button A flashes and the digital
2.
display shows the factory set value. Press A to choose the setting.
Press buttons B or C (up or down) to change the setting.
3.
Press Start button to save the setting.
4.
8
Do not
place
objects in
detergent
tray or
block it with
dishes
Adjust
upper rack
as needed
for large
items.
PUSH
Improved drying for glasses and
plastic, by increasing the tempera-
ture and length.
Dispenses the amount of rinse aid,
which affects drying.
Adjust the sound level of the signal
beep at the end of the cycle. Or turn
off (›:‹‹).
Light projected on the floor to signal
active wash cycle. Set to on or off.
Unit turns itself off after cycle is com-
plete, either after 1 minute, ˜:‹‚ or
after 2 hours, ˜:‹ƒ .
x (x can be any number).
MAINTENANCE TIPS
Scrape Clean surfaces with damp cloth and mild soap.
off
NOTICE: Do not use abrasives or bleach based cleaners. Do not use stainless
food,
steel cleaner on black stainless or anti-finger print surfaces.
but
Clean the filter 3-12 times a year, depending on usage.
do not
Unscrew the Large Object Trap as illustrated and remove the entire filter
1.
rinse.
system.
Remove the micro-filter from the fine filter, rinse the filters under running
2.
water clean with a soft brush.
Reinstall the filter system in reverse sequence, align arrows.
3.
FREQUENTLY ASKED QUESTIONS
Q
Why is food left on dishes?
:
A
It is possible the dishes do not have adequate clearance between them.
:
Also, be sure nothing is blocking spray arm and that the filter is clean. Select an
intensive cleaning cycle.
Q
Why does the cycle run a long time?
:
A
1. Sensors in the dishwasher automatically increase the cycle time to ensure a
:
good wash when heavy soil is detected.
2. Incoming water may not be hot enough and the dishwasher has to heat it.
Q
Why is E:XX (X can be any number) displayed?
:
A
This is an error code. For example, E:22 indicates there is water in the sump
:
because the filter is blocked or needs cleaning. See the Use and Care Manual
for a list of error codes.
To access the full Use and Care Manual, go to:
www.bosch-home.com/us/service/get-support/owner-manuals.
2
1
9