Electrolux LYB1AE8W0 User Manual page 31

Problem
Water flows inside the refrigerator.
Water flows on the floor.
The temperature in the appliance is
too low/too high.
If the advice does not lead to the desired
result, call the nearest Authorized
Service Centre.
8.2 Closing the door
1. Clean the door gaskets.
Possible cause
Temperature set in the appliance is
too low and the ambient tempera‐
ture is too high.
Food products prevent the water
from flowing into the water collector.
The water outlet is clogged.
The melting water outlet is not con‐
nected to the evaporative tray above
the compressor.
The temperature is not set correctly. Set a higher/lower temperature.
The door is not closed correctly.
The food products' temperature is
too high.
Many food products are stored at
the same time.
The thickness of the frost is greater
than 4-5 mm.
The door has been opened often.
There is no cold air circulation in the
appliance.
2. If necessary, adjust the door. Refer to the
3. If necessary, replace the defective door
Solution
Set a higher temperature. Refer to
the "Operation" chapter.
Make sure that food products do not
touch the rear plate.
Clean the water outlet.
Attach the melting water outlet to
the evaporative tray.
Refer to the "Closing the door" sec‐
tion.
Let the food products temperature
decrease to room temperature be‐
fore storage.
Store less food products at the
same time.
Defrost the appliance.
Open the door only if necessary.
Make sure that there is cold air cir‐
culation in the appliance. Refer to
the "Hints and tips" chapter.
"Installation" chapter.
gaskets. Contact the Authorised Service
Centre.
ENGLISH 31