Table of Contents
Advertisement
The exposure standard for wireless phones
employs a unit of measurement known as
Specific Absorption Rate (SAR). The SAR limit
set by the FCC is 1.6 W/kg
SAR tests are conducted using standard
operating positions specified by the FCC with
the phone transmitting at its highest certified
power level in all tested frequency bands.
Although the SAR is determined at the highest
certified power level, the actual SAR level of the
phone while operating can be well below the
maximum value. This is because the phone is
designed to operate at multiple power levels so
as to use only the power required to reach the
network.
1. In the U.S. and Canada, the SAR limit for mobile phones
used by the public is 1.6 watts/kg (W/kg) averaged over
one gram of tissue. The standard incorporates a
substantial margin of safety to give additional protection
for the public and to account for any variations in
measurements.
1
.
In general, the closer you are to a wireless base
station antenna, the lower the power output of
the phone. Before a new model phone is
available for sale to the public, it must be tested
and certified to the FCC that it does not exceed
the limit established by the government-
adopted requirement for safe exposure. The
tests are performed in positions and locations
(e.g., at the ear and worn on the body) as
required by the FCC for each model. While there
may be differences between the SAR levels of
various phones and at various positions, they
all meet the government requirement.
The FCC has granted an Equipment
Authorization for this model phone with all
reported SAR levels evaluated as in compliance
with the FCC RF exposure guidelines. SAR
information on this model phone is on file with
the FCC and can be found under the Display
Grant section of http://www.fcc.gov/oet/fccid
after searching on FCC ID printed in the label
on the phone.
71
Advertisement
Table of Contents
