Table of Contents
Advertisement
1
Screw light kit screws from the
hardware bag halfway into
the light kit adapter. It does not
matter which two screw holes
you choose.
4
Connect the plugs from the upper and
lower switch housings. Make sure to line
up the colored markings on the connectors.
Note:
Fan style may vary.
Repeat x3
Hunter Pro Tip:
Want to install your fan without a light kit?
Go to
www.HunterFan.com/FAQs
fan without the light kit?"
Ceiling Bracket
Downrod
2 of 6
Light Kit Screw
bag
5
Partially install two of the light kit screws
found in the
hardware bag. Align the
notches in the sides of the lower switch
housing with the screws on the upper
switch housing. Twist the lower switch
housing clockwise to lock into place.
Installing the Bulbs and Glass
Install a bulb into each
of the sockets. When
necessary, replace with
bulbs of same wattage.
and click "How do I install my
Hanging Fan
Assembling the Light
2
Feed the wire plug through the center
hole of the upper switch housing,
then wrap keyhole slots around the
screws and twist counterclockwise.
2 of 6
Light Kit Screw
bag
To install the shade, first loosen
the thumb screws. Raise the
shade to the light fixture. Tighten
all thumbscrews securely.
Repeat x3
Repeat x3
Note:
Fan style may vary.
Wiring
Canopy
3
bag
Insert a third screw, found in the
hardware bag, into place and
then tighten all three screws.
WARNING
FAN FALL HAZARD
Make sure all three screws are tight to secure
the upper switch housing to the mounting plate.
6
bag
Install the last light kit screw.
Tighten all three screws securely.
WARNING
FAN FALL HAZARD
Make sure all three screws are tight to secure the
lower switch housing to the upper switch housing
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Blades
Light
1886
1 of 6
Light Kit Screw
1 of 6
Light Kit Screw
ON
8
Control
Advertisement
Table of Contents
