Advertisement
Quick Links
illc
@Jc ~[illDv~
APPROVAL RATINGS AND CERTIFICATION
All models comply with ANSI Z21.1 0.3 CGA4.3
All models comply with ASHRAE/IES 90.1 b-1992.
C.E.C. California Energy Commission
FEATURES
80% thermal efficiency and standby energy losses approximately
one half of comparable standard atmospheric models
INDUCED DRAFT BUILT-IN BLOWER - Blower comes factory
mounted and wired to the top cover with 6 foot power cord.
Ideal for installations where negative pressure in the building is
present. Blower proves draft prior to ignition. No drafthood or
barometric damper required.
METAL VENTING
-
Category
I appliance,
uses standard
metal
single wall or "B" type vent. Can be commonly
vented with other
Category I appliances. Vent connects directly to the blower outlet.
JACKET - Heavy gauge steel with baked enamel finish over a
bonderized undercoat.
FOAM INSULATION - saves fuel, helps reduce standby heat
loss.
GLASS LINED TANK - Glass specifically developed by A.a.
Smith for water heaters, is permanently fused to steel, providing
years of corrosion protection and dependable use.
HONEYWELL SMARTV
ALVETM
- Integrated control module and
gas valve, this control monitors all critical water heater functions
including temperature (up to 180°F, 82.2°C) main valve operation,
blower operation, energy cut-out, and hot surface igniter. The
diagnostic
LED enables a technician
to quickly and easily
service the system and verify safe and efficient operation.
ANODE - CoreGuard long-life, stainless steel core anode rods.
BURNER
-
Heavy duty cast iron burner. Available in both natural
and propane gas.
FULLY TESTED
FOR SAFETY AND PERFORMANCE
- Design
classified by Underwriters
Laboratory
for 180°F hot water service.
Meets rigid requirements
of the National
Sanitation
Foundation
when
equipped
with the optional
leg kit. Certified
for use on
combustible
flooring.
c
EASY INSTAllATION
- All components are factory assembled
and 100% tested prior to shipment. Only gas, water, electrical
and venting connections
need to be made. No major field
adjustments are required for proper operation. Includes T&P valve
and drain valve.
Limited
Warranty
If the tank should leak any time during the first three years, under
the terms
of the limited
warranty,
A. O. Smith
will furnish
a
replacement
heater; installation,
labor, handling and local delivery
extra. THIS OUTLINE
IS NOT A WARRANTY.
For complete
information,
consult the written warranty
or A. O. Smith Water
Products Company.
EASY CLEANING
-
Hand hole cleanout allows easy cleaning.
Warranty does not apply to product installed outside of the United
States of America or its territorial
possessions
and Canada.
OPTIONAL LEG KIT - Meets NSF Standard 5 with leg kit
#6280-4 BTI 80 & 1 00
A 104.9
July
2000
INDUCED DRAFT COMMERCIAL GAS TANK-
TYPE
WATER HEATERS BT180-100
Advertisement
